The Extraflame boiler is a great heating solution developed from the most All Extraflame products are built in compliance with the following Directives: 89/ . ‘Pellet refill pipes on store’. ‘Feed auger system routed outside to wooden clad 3 tonne storage’. ‘Extraflame LP30 plumbed to heat house and swimming pool’. Extraflame LP30 Manual Online: Alarms Table. ALARMS TABLE ALARMS Reason Indicates the presence of an alarm. Flue gas motor fault Flue gas probe fault.
|Country:||Papua New Guinea|
|Published (Last):||9 June 2004|
|PDF File Size:||2.64 Mb|
|ePub File Size:||9.32 Mb|
|Price:||Free* [*Free Regsitration Required]|
lp14 – lp20 – lp30 – La Nordica
The problems correlated to the amount of fuel can be divided into categories: Intervenes by blocking fuel sxtraflame whenever the pellet tank t reaches the limit of 85 C.
The cooling circuit must be activated by a heat safety valve such to guarantee that the limit temperature set by the Standard is not exceeded.
The following table gives all weekly programmer function parameters. If the stove has functioning problems owing to the quantity of pellets, adjust pellet feeding directly from the control board. Add to Watch list Watching. exgraflame
Extraflame LP30 Pellet Boiler
An additional expansion vessel must be installed for lp0 higher content of water. The connection pipe must be realised in order not to present scales or deposits storage points. Amongst the inconveniences caused by bad quality feeding water, the most frequent is the scaling of the heat exchange surfaces. Baxi Combi HE.
Extraflame LP30, vacuum feed system and 3 tonne hopper
Installation must be performed by an authorised technician It is possible to thermostat a room adjacent to the room where the stove is positioned: Add to Watch list. It is therefore recommended to carefully check the extraflams on receipt, immediately informing the dealer of any damage, making a note on the transport document and on the carrier’s copy.
The smoke channel must allow the recovery of soot or be brushable. If the flue should catch fire, be equipped with suitable systems for suffocating the flames or request help from the fire service.
No additional import charges on delivery.
Installation and maintenance instructions. Extrafoame appliance is used as prescribed in the instructions manual provided with all products. If it is damaged or lost,request another copy from the area technician. See the images for feeding pellets. Watch list is full. If difficult to find given preferential schedules or changed delivery address.
Installation must be performed by qualified staff, which assumes complete responsibility for the definitive installation and consequent good functioning of the product installed. UNI heat generators fed with wood and other extaflame fuels: It is forbidden to have other air supply channels and pipes for plant engineering, especially if over-sized, transit inside the smoke channels.
The smoke channel must have constant section. It is recommended to wash all the pipes of the system well before installation to remove any residue that could lp300 the correct operation of the appliance.
The diameter of the discharge piping must not however be lower than that of the outlet connection of the safety valve. UNI chimneys: Possible air in the system.
Work During the work phase, the stove reaches the set power; see following item. In particularly adverse conditions strong wind, freezing safety systems may intervene that switch the stove off.
Biomass Parts and Service Spares, Boiler Spares & Parts
The hydraulic system must be completed in compliance with the guidelines of the regulations and the manual. To clean the majolicas, it is recommended to use a soft, dry cloth. Once the temperature set has been reached, the machine will work at minimum.
The appliance controls the water temperature through a probe installed as per standard, which modulates machine power until the set point set is reached.
Maintenance operations guarantee correct functioning of the product through time.